03 Engine, Internals - OM606

Crankshaft

• 03-1101HA - Checking, correcting setting of bracket of TDC sensor
  • G14 - Check, correct position of bracket of TDC Sensor
• 03-1600HA - Removing, installing belt pulley/ vibration damper
  • L16 - Remove the pulley / vibration damper
• 03-1600HB - Belt pulley/vibration damper as-built configuration
• 03-1600HC - Belt pulley/vibration damper as-built configuration
• 03-1600HD - Belt pulley/vibration damper as-built configuration
• 03-1600HE - Belt pulley/vibration damper as-built configuration
• 03-3000HA - Replacing front crankshaft radial seal
  • E15 - Installing front crankshaft radial seal
• 03-3063HA - Replacing rear crankshaft radial seal
  • H15 - Installing rear crankshaft radial seal
• 03-4351B - Removing and installing crankshaft
  • K15 - Examining bolts of crankshaft bearing caps
• 03-4355A - Measuring crankshaft and installing bearings
  • M15 - Installing crankshaft radially in bearings
  • C16 - Assigning crankshaft bearing shells
  • G16 - Installing crankshaft axially in bearings
• 03-5000HA - Installing, removing retaining lock for crankshaft/starter ring gear

Connecting rods

• 03-6111HA - Testing, repairing connecting rod
  • K14 - Tightening connecting rod bolts
  • L14 - Press-fitting new connecting rod bush
  • N14 - Aligning connecting rod
  • A15 - Checking connecting rod bolts

Pistons

• 03-7021B - Removing, and installing pistons
  • B15 - Removing, installing oil deflector plate
  • C15 - Measuring piston projection
• 03-7311HA - Removing and installing pistons rings

Flywheel

• 03-8001HA - Removing and installing flywheel/driven plate
  • M16 - Examining bolts for flywheel / driven plate
• 03-8022A - Checking, remachining flywheel
• 03-8312A - Replacing ring gear of flywheel
• 03-8400A - Removing, installing needle bush in two-mass flywheel
• 03-8400HA - Removing, installing grooved ball bearing of crankshaft

---